looking at putting some audio gear i have in to my vy series2 clubby and was looking for some feed back on different ways i could set up the stuff i have
pioneer dvd 4volt
type r alpine 6.5 splits
pioneer 5 way 440 watt 6x9s
2 12 inch alpine subs type r
2 us amps 4ch 4 x 300 or 2 x 600 watt
2 response amps 2 x150 rms or 1 x 450 rms
3 1 farad caps
and keeping in mind i havnt ruled out getting a alpine mono block 1000 rms for the subs
any help or feed back would be greatly appreciated
cheers nathan
I'll ask Greg to look into it as Im not 100% with the audio.
Hope you don't mind me giving my opinion even though its in the ASR section, but here's what I'd do.
- none of those amps are really going to do the subs justice, so I would be losing the us amps and running the subs off the alpine monoblock you said was an option.
- run the splits and 6x9s off the response amps, just make sure you set the gain properly as they will be a bit overpowered at high volumes (at least the splits will be, not sure about the 6x9s)
- do what you will with the caps. I'd say they are a waste of money but it sounds like you already have them so it can't hurt to throw them in
EDIT: Are the subs already in boxes? If you are going to have to make boxes for them, the type to make will depend on what music you listen to and whether you have space constraints etc
EDIT AGAIN: Do the subs have 2 or 4 ohm voice coils? If you have the option go with the 2ohm versions so you can run the pair at 2ohms and get the most out of the monoblock
Last edited by Philthy; 14-07-2009 at 03:22 PM.
http://shoppingsecure.com.au/ - JC's Rep
PM me or email philthy@shoppingsecure.com.au for all your stereo needs
mate go for it, everyones here to help. Only thing ya cant do in this forum is try to sell dash LED conversion kits or AUX in kits![]()