help with wiring 6x9's

[pukka]

hi all.
i am installing 6x9's on the parcel shelf in my vy executive with stock h/u.
i am happy with putting the wires under the trim and getting the speakers in their position.
i am just confused about where do i conect the wires to at the head unit (there are so many little holes in the wiring behind the h/u).
any help will be great.
thanks

[holdenboy]

Well if youve ran new speaker wiring from the speakers to the head-unit you can just cut the correct wires (leave enough room so you can join them back up at a later date) at the plug behind the stereo, the wiring colours to look for are:

Rear left speaker:
(+) - Brown/Black Stripe
(-) - Yellow/Blue Stripe

Rear right speaker:
(+) - Blue/Orange Stripe
(-) - Blue/Black Stripe


Usually i just run the new wires to the sill panel covers near the "B" pillar, and cut / join the wires to the existing wires before they head into the rear doors.

[Luke0011]

It is faster to run wires to the head unit than remove the sill panels on either side to connect into the rear doors.

[VYMAD]

It is faster to run wires to the head unit than remove the sill panels on either side to connect into the rear doors.

I disagree, when I did mine, I tapped into them under the sill panels, too.

[holdenboy]

Yep i disagree too Luke, i dont totally remove the sill panels.....just undo the torx screw at the B pillar and the screws. This enables enough room for you to be able to access the loom and cut / solder new wiring from there.

Wouldnt you have to remove the sill panel covers anyway to run new wiring to the head-unit?
I do anyway, run the new wiring along with stock loom.