VY Amp power
Hi all,
I'm wondering whats the easiest way to get two 4 gauge runs through the fire wall on my VY SS? Don't particularly want to cutup the main power grommet if i can avoid it (plus it seems to be a void in between the two grommets? Is there a way to get back in from inside the guard?
I'm planning to run a sub on high levels off the rear speaker channels until i get a processor (still deciding between alpine h800 and audison bitone). Which i will most likely come to ozzie to get.
Cheers
Taylor
//There Ain't No Rest For The Wicked...
Rough As
2 4 gauge? if ur goin to do that, run 0 gauge and a distribution block
I've already got two 4 gauges because i had one running in my last car then when I put the second amp in just grabbed another one and ran it down next to the other one.
Initially i want to run one 4 gauge, since the factory system lacks bottom end, to get the sub going. Then I probably will just grab some 0 gauge and change it over.
There dont appear to be any spare factory grommets on the firewall that i can see, i'd rather go through the factory power grommet then drill a hole.
Rough As
just go thru teh firewall where i went thru,
That was the grommet I was looking at. Quite tight to get at. Did you just slit it with a knife and push through? Was it hard to get from inside? I removed the aircon bit on the end and you can kinda see it but cant really get my hand in there. Cheers
Rough As
umm, yeah easy just cut it with a sharp knife or something and slide teh wire thru, ohhOriginally Posted by m1lky
also it is much easier with a coat hanger to tape the wire to it so it can go easy thru the hole, mine was done with 8 gauge then 4 gauge then i did 0 so.. make the hole then poke it with a coat hanger
Sweet. I'll do that tomorrow. Cheers for your help mate
Posting Permissions
LinkBack URL
About LinkBacks
Reply With Quote