Kick panels ans sill panels how the ????

[AttaBoy]

Kick panels and sill panels how the ????

Hey guys,

I need to run the amp power cable an RCa's through the drivers side kick panels and unders the sill panel (the one that goes all the way to the rear) so How do I take them off?
Do I just pull it off? I'm worried I might snap em off!!
Cos I can't see any screws that hold them??
Any tips and step by step instructions would be awesome!!!
(Is this the same with the passenger side panels??)

Thanks in advance!!

Attaboy.

 

[Tasmaniak]

From memeory, you must first remove the side strip. Also the seal around the door will need to be pulled off

 

[84_vk_wgn]

yer its easy mate, just pull off small section of the door seals then if there is a cover over where the drivers seat belt is you mite have to take that off aswell. then the panel just pulls off, it has little metal clips inside the panel which hold it on. same with the drivers side rear and the passenger front and rear.
hope this helps.

 

[Phreddy]

Hey Attaboy. (G'Day 12V!)

You need to pull the centre strip out of the door sill trim, then you can "squeeze" it together and pull it up to get it out. The kick panels I can't quite remember - I have a sneaky feeling there is one screw in each of them, but I might be getting mixed up with my old VT.

Hope it helps. Cheerz!

 

[Tasmaniak]

oh oh oh oh Phreddy been meaning to email you! Brace your inbox big boy!