VP new install

[VP_belina]

just bought a total kit,
explode 12" sub
explodes splits
panasonic CQ-C5401W head
audiolinie 800w mono
audio 800w 4 ch

no idea how to install, been reading this site all night, i have got the whole idea of connecting the amp power cords and such to the bat and thur the firewall down pat, but whats the go with the fuse block and what connects into it and out? it says something about having it as close to the bat as possible, but i am not sure what to do, i dont cut my power cable or anything do i?? i am going to power all four speakers thur the amp, so i just run a set of rca cables to both amps and then what wires go from the speakers to the amp?? the guy at audiobarn said i didnt need anymore cables or anything, or should i have gotten speaker wire?? or do i use whats already on the speaker and try and get it to reach the amp? or do i just add more wires to the termanials and run that to the amp as well??

also, the rca cables, they run down the back of the head unit and how do i get them to the back of the car? under the console or something? and what do i have to take off to put the rca cables thur so i can run them to the back? i presume get them out from under the middle somehow and then run them down under the skid guards on the doors?

Thanks any advice would be apperciated

[VP_belina]

ah brainwave, the fuse spilter is connected to the power cable from the battery, and then i should have two short thick power leads one to the mono and one to the 4 channel?? but then where does the ground cable connect to?

[VP_belina]

all installed, took 6 hours but all sweet, except having problems fitting the deck back in flush, hopefully having the right angled rca cables at the back of the deck will help