VS/Lexcen central locking not working after cd install

[anthony0281]

Has anyone had a problem with central locking not working after a cd unit has been installed to a T4 lexcen(aka VS comm), thankfully I did not do the install myself, I am thinking that they have used the wrong wires and maybe sending wrong signal to BCM.
Does the BCM need any signal as before the radio would have to be powered from or checked by BCM for correct radio pin installed. How does this normally work when non-gen unit fitted?

[Stretchomatic]

the only way i see this making sense is the car shares the fuse for the radio and central locking, but if the radio works fine the locking should...

[JJ's VR]

Did you have any front speakers (inside front door pods) installed? If so, perhaps check wiring loom between chassis and front doors. They might have accidently pinched/cut the central locking wires, these run through the rubber boot between chassis and front (&rear) doors. I wouldn't worry about the BCM just yet, highly unlikely.

[krisbird112]

Has anyone had a problem with central locking not working after a cd unit has been installed to a T4 lexcen(aka VS comm), ?

i own a 1996 vs toyota lexcen and there is a small computer above the fuse bit just under to the right of the stearing rod check the connections if they are conected good and peoper find another moduel its held up by 2 small screws this moduel controlles few parts of the engine and all lights guages locks and very rarely suspention