Highbeam electrical problem, vl

[calais24/7]

Wasn;t sure wether i should post here or in vl section but anyway. When my low beam's are turned off and i go to flash the headlights only the rhs one works. But when my lowbeams are turned on and i need high beam for greater vision they both work. (Both times the stalk is needed to be pulled towards the driver)

 

[GothicKidd]

You could have a blown Bulb.. Try replacing the LHS bulb..

 

[RiCeY]

Wont be the bulb if it works on high beam constant.

I'll try find a schematic and have a look.

 

[calais24/7]

nahh man it's not the bulb and not a fuse either. And that would be good ricey

 

[GothicKidd]

Ah didnt read it properly.. If they work when the lights are on.. They should work when they are off and you want to flash Id say check all your wires near the headlight then :\

 

[calais24/7]

yeaah iv'e poked around a little bit and can't seem to find much. And it shouldn't be a loose wire or broken wire otherwise it shouldn't work at all. ehh typical vl and problems