Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

vz wagon trailer wireing harness

baroofy

New Member
Joined
Feb 21, 2009
Messages
22
Reaction score
0
Points
1
Members Ride
vs equip
Hi, i have just fitted a 2nd hand tow bar to my vz wagon. I want to mount a flat trailer plug under the rear plastic bumper. but i am not sure where to run the wires from the plugs in the right rear to the trailer plug underneath. (are there any pre drilled holes). i prefer this set up compared to the flat wire comming out the tail gate. thanks for any help.
Cheers Baroofy
 

bcw61

Member
Joined
Sep 14, 2009
Messages
357
Reaction score
18
Points
18
Location
Northern suburbs of Adelaide
Members Ride
VZ 2005 Executive Wagon
If you remove the rear bumper, you will note on the righthand side of the vehicle, that there is an unused rubber grommeted access hole adjacent to the interior air outlet vents. I used this hole when I fitted a reverse parking sensor kit, but there is no reason why you could not use this access point for the towbar wiring harness.
 

Trevor 062

Member
Joined
Feb 10, 2005
Messages
466
Reaction score
3
Points
18
Age
60
Location
St Clair
Members Ride
2012 VE S2 SSV REDLINE & 07 VZ ACCLAIM WAGON
As bcw61 just said my VZ wagon has the tow bar wiring plug etc in that O/S vent door...The wiring loom is actually flat,
so that you can close the tailgate without damaging the loom..
 
Top