drewdc90
New Member
- Joined
- Jun 17, 2008
- Messages
- 23
- Reaction score
- 1
- Points
- 3
- Members Ride
- VP Executive
I have a VP and did an engine swap with a VR and removed the non working air con setup from engine bay but left wiring attached to nothing. When the car starts it runs for1 min then the fan starts and check engine light comes on and both stay on. I changed back to the original sensors that worked fine before the change but still the fan comes on and stays on. Will this affect the mixture? I have an Ellerys book but the wiring diagram is not very good. I don't have access to a diagnostic cable so any help would be great as I am ready to install a seperate sensor and relay to power the fan.
Last edited: