Reposition Washer Squiters

[lumpy]

I want to remove the washer squiters from the bonnet and relocate them elseware. Has enyone done this?

[1991_Vn2nV]

...why? Is there any special reason for it?

[1vngal]

Hmmm....I agree with 1991_Vn2nV, is there any point? You'll only be left with 2 holes in your bonnet, and the water is still going to squirt on the windscreen.....

[Shortstuff]

I've seen it done. They had been hidden on the scuttle panel just under the rear edge of the bonnet (not on a Commodore though). It wouldn't be too hard to re-route the piping and make new holes for the washer jets to fit in, but as 1vngal said, you'll then be left with 2 holes in the bonnet which will be a pain to fill and get sprayed up.

[lumpy]

If I get a fibreglass bonnet, I will have to drill holes, so I recon it would look good if they were hidden like the VZ commodores.

[1991_Vn2nV]

What model is this for? All the fibgreglass bonnets have looked at have the holes in them for the washer jets anyway.

[NORTI]

not custom ones



D.

[1991_Vn2nV]

Oh ok. The ones i've seen must have had them put in.

[Infanti]

just keep a spray bottle of water under you seat and spray the front window whilst hanging out of you drivers side window. That way you can extend the washer tube along the bottom of your car and mount them so they spray the back wheels. All you gotta do then is fill your wiper fluid with baby oil, vegetable oil, etc and drift away...........good fun!

[naf33n]

just put it where the vz have them, easy as

[ENV5]

yes i need to do this coz theres no way im drilling holes in my monaro bonnet ill just put them on the plastic bit under the bonnet