Installing Foglights VZ Adventra

[Pete_perth]

Hi All,

Hope someone can give me some advice, I am going to be installing some fogl ights into my Adventra and just wondered if anyone know's how to remove the factory plastic covers that Holden put in instead of the fog lights. I don't want to start bashing around in case there is a trick to it. I attached a picture to show you what I mean. Any advice would be great.

Cheers
Pete

[PaulSV6]

You could probably push the covers out from inside the front bar, there will be some clips that keep it in place.

Unless the covers are part of the front bar! you'll be outta luck.

[Pete_perth]

You could probably push the covers out from inside the front bar, there will be some clips that keep it in place.

Unless the covers are part of the front bar! you'll be outta luck.

Thanks Paul, I can move the covers around, so I know they arn't part of the actual front bar (thank goodness). I will keep trying to figure it out. If I do I will post it on here in case anyone else tries to do it.

[Torquative]

from memory when i did the VX they push out from the rear, they do just clip in

Search for VX or VY or VZ fog lights, its all the same setup.

You also ned the new healight switch with pullout fog light switch and the relay

The SX6 doesnt look right without them, dad wasnt going to order his with them until I pointed out how ugly they look, their designed to have them so why not have em even if you never use them

[Pete_perth]

from memory when i did the VX they push out from the rear, they do just clip in

Search for VX or VY or VZ fog lights, its all the same setup.

You also ned the new healight switch with pullout fog light switch and the relay

The SX6 doesnt look right without them, dad wasnt going to order his with them until I pointed out how ugly they look, their designed to have them so why not have em even if you never use them

Thanks heaps Torquative, I will take your advice. If I get them out without destroying my whole front bar I might put together a quick "How to" I have been wanting to do one for ages, but everyone seems more knowledgable than me LOL

[Pete_perth]

Thanks for everyone's help. I have now installed my foglights and new headlight switch into the VZ Adventra. A lot easier than I expected, all the wiring was there, all I needed to do was install the actual fog lights, insert a relay into the relay compartment, and put in a new headlight switch that allowed for fog lights. Everything works, even the little dash light that says you have your fog lights on.