hi

[jadorff]

Hi everyone and thanks for your help the last holden i owned was a hq have had fords since then idecided to get a holden i have a 2003 wh statesman low ks nice car this a very good form being on a couple of bike forms also ,these are very heaplefull and informotive as is this so iagain ask for help how do you remove the panel from under the steering colom to get to the fuses therer is no promblms just cant see how it is done thanks again for your replies

[EDGE3]

Undo a few clips then that they have but mine has screws that I have to undo

[Grennan]

There are no screws.

You have to firmly pull down. It is "locked" into place by a few notches in the plastic and some clips on the dash facia.

I find its easier to get it off by pulling directly down by holding onto the edge directly next to the steering wheel column and the edge nearest to the pedals. It does feel awkward, but once you get it out and have a look you'll see how it fits in.

Thats how it is in the VX, I imagine the WH isnt much different.

[DevilDRake]

There are no screws.

You have to firmly pull down. It is "locked" into place by a few notches in the plastic and some clips on the dash facia.

I find its easier to get it off by pulling directly down by holding onto the edge directly next to the steering wheel column and the edge nearest to the pedals. It does feel awkward, but once you get it out and have a look you'll see how it fits in.

Thats how it is in the VX, I imagine the WH isnt much different.

Same with my VY. 2 clips down the bottom you just take it out off, then 2 clips at the top.