Got a set of new fog light flutes for the Calais, and while they are not painted yet, I am still happy with the overall product, and will hopefully paint them sometime next week! anyway this was a cheap and simple mod and was well worth it!!
TOOLS/ITEMS REQUIRED
Hole saw
Silicone gun
Silicone
Drill with average size bit:P
80 grit sand paper
STEP1 Holding up your flute, in line with the mouth piece on the bumper, mark around the inner part of the fog light flute!PIC 1
STEP2Now drill 2 starter holes, and useing your hole saw cut out the rough circle!
PIC 2&3
STEP3Replace your flute and check for level, now mark around the flute again, now remove the flute and mark approx 7ml under the line you have just made, now cut the inner line out! PIC4
STEP4Now rub back the area on the bumper where you have just cut out and apply silicone!PIC5
STEP5Fit flutes and stand back and check for level, adjust accordingly
Here is a before and after shot for comparison!
Sorry about the shadow, i will take a better shot this arvo!
Not sure if silicone is the way of adhereing them to the bar I used the factory clips after I made slots in it and I take it you are goin to paint them on the bar?
This is my vr that I rebuilt ....CLICK HERE to see my vr on Cardomain
......if you want to check it out......Anyway make sure you rubbish a ford daily ....I am a 4DH8RZ Club lifetime member .................new members joining everyday
MY RIDE 96 calais
http://forums.justcommodores.com.au/...96-calais.html
ALSO MY 1972 VALIANT CHARGER IN THE BUILD
http://forums.justcommodores.com.au/...t-charger.html
where did you pick up the flutes from?
MY RIDE 96 calais
http://forums.justcommodores.com.au/...96-calais.html
ALSO MY 1972 VALIANT CHARGER IN THE BUILD
http://forums.justcommodores.com.au/...t-charger.html