Recent content by hsvwgn

The pump is correct, you had to use spacers as you are not running the bigarse a/c bracket!

Your rear main oil leaking issue could be just a symptom of excess crankcase pressure, caused by a faulty PCV system. if I were you I would check to see if the small port in the throttle body that connects to the PCV valve and passenger side rocker cover is not gummed-up and blocked. I have seen...

1964 Holden EH

I found out the hard way, doing a wedding for a friend and getting a big 'V' scratched into the bonnet from the ribbon! Any ribbon will scratch, especially flapping against the bonnet after a bit of dust and at highway speeds. The solution is to keep the ribbon completely off the bonnet using...

Mate that is a Jacar/Dick Smith programmable remote, about $40.00 worth. You just use your old remote (if you can get it to work) and follow the instructions included. Well worth it!

Exactly, especially the fitting into the throttle body, make sure that isn't blocked.

Hi all Just a thought, if the vehicle had personalized plates the transfer of Reg. Is different as well, especially if the seller wants to keep his plates.

Hi afracing, do you supply the 'slip-on' spacers too? I am after 4 of 5mm thick spacers, 5 x 120mm stud pattern, 12.5mm stud holes and 69.5 hub hole diameter. Please PM me at your earliest convenience with your ability to supply and price for the 4 Spacers, including Shipping to Melbourne...

Hi darky, I have seen this before, recurring problems, same as yours, on a mates 308. I needed his panel beating skills so I promised to fix his engine. I bought NEW head bolts and torqued the heads down correctly, and it lasted his thrashing, and he thought I was a genius! Pretty simple really...

Hi Aaron Prior to adjusting the shoes, did you back off the handbrake adjustment at the primary cable/ equalizer link? If you didn't, the shoes will be held out mechanically (falsely) by the handbrake adjustment and the master cylinder will have to displace an excessive amount of fluid to make...

Ignition Timing retarded?

Hi sk2304 I reckon it's a easy fix without dismantling the pump. I would think that you have put the Oring on the pump outlet pressure fitting on the wrong groove, covering a small orifice. Remove the fitting and check it. Good Luck Dave

Even easier way, connect 12V to boot light terminals, then use remote to open.

BFPM = 93 5.0 litre manual 185kw HSV. Just google" Delco Memcal Codes "for more info! Cheers

VP Calais HU is Eurovox Model 7380, and look as you described.