Recent content by tt turbo vh

hi guys i need wiring digrams for low beam turn signal and dash illumination i hav put an ecotech into a vr i put in a vs bcm i got the engine running the doors lock and unlock but no lights or turn signals or dash lights. thanks

hi guys i need a wiring diagram (pinout) fot a vs mid bcm i have put an ecotech into a vr. the plugs are wired up diffrent (same amount of pins) i got the pinout of the vr bcm thanks

im doing this project at the moment its alot of work the bcm (body controle modual) will need to be changed to a vs BCM and the key head will need to be changed the bcm is matched to ur key head. the data wire (red wire black trace) will need to be moved from pin 19 to 20 i think im still yet...

hi guys i need a wiring diagram (pinout) for a mid vs BCM iv put an ecotech into a vr and i need to cange the vr BCM to vs BCM the pinout's are diffrent from vr to vs thanks..

hay to go 355 you will need to notch the block to fit the crank if you use a vp block vt block this is already done. use chev 6inch h beam 350 rods thay are longer less bore scuffing (more reliable) and ur crank will need to sute chev rods. if ur going s/c you will need dished forged pistons if...

hay did u drain the coolnt b4 pulled the inlet manifold off? or there might be a low spot on ur inlet manifold around the water jackets because some people use sanding disc's and create a low spot. Good luck

hay make sure it didnt over fill and filled up ur charcoal canister if it has when it perges extra fule will be geting into ur engine making it run rough. disconnect ur perge lines to ur engine and see if it runs better. Good luck!

hi im doing the same conversion at the moment im having trouble wont start its ecotech into vr iv been told u will need to change the pins on the loom to use a vs bcm in ur vr dash loom.( so i have been told) and the plugs are diffrent in the engine bay there behind the booster on the vs but on...