holden v8 5.0 motor suit project (vic)

[ssn8r]

It is a VN 5.0 v8 efi motor..i only bought this motor a while back only for the banana manifold and injection setup for epa etc as my current inlet manifold is a c.o.m.e and wouldnt pass, so now the rest of the motor is just waiting around doing nothing. i was thinking of building a big cube stroker out of it one day but no time, if it doesnt sell i actually mite..


You will get (minus the bananas) everything the 2x heads bolted on still to the block, wiring loom, sump, headers, ecu, module, crank pulley, pulleys, some other small accessories.. etc

All valvetrain and bottom end comonents are still in motor!! Untouched!! I do not know how good or **** the motor runs, as i havent started it and dont care as i said i only needed the banana setup off it!!

it will suit a a project, stroker or anything along those lines.

Asking for $500, bargain!! All you will need is a inlet manifold and off you go!

can get pics this week if you really want

email preferred: ssn8r@bigpond.com
no time wasters plz.

moe

[greenfoam]

far out :P I would have scored big time if I lived in Melbourne I bet this is long gone by the time I wake up tomorrow, what a deal

[ssn8r]

hehe no it aint gone yet but i have a few queries in the mail..

also, i have a set of polished holden valve covers i will throw in with this motor, i just realised i have my old set of valve covers that are polished, i no it aint much but now ul have 2 spares with this motor.

[Blown V6 Hatch]

Where abouts in Vic are you mate?? Know roughly how many K's it had done??

[ssn8r]

in south east mate, dandy south to be exact.
honestly i do not know how many k's it has done.

[ssn8r]

motor is sold
you may now close the thread mods / admins
thankyou

[Fatvl308]

how much just for the heads

[Pub247]

Umm did you read the post above yours? ^^^^^^^^

Pity this wasnt still around i would snap it up right now