VT Drag Project

[grovers_1983]

**** man thats lucky the vt dident roll to and good to hear you all rigth

[sweefu]

shit to hear bout that mate, but good your all clear, same with the car.
good luck with it

[SquishyShoes]

Wow, sounds like a lucky break (for the car) good to hear you're alright.

[Troy5L]

thank god ur alright and its good 2 hear the vt didnt roll, so much hard work and you would hate it to go all down the drain...sooooooo any new updates?

[sweefu]

any updates mate?

[VT-565]

Been a while.

VT copped a bit of damage, I've just repaired the trailer and returned it to its owner.
Broken welds, bent cage, caved in panelwork.
Not nice.

[sweefu]

crappy to hear that mate. will you keep the project going or transfer the running gear into another car or??
Cheers.

[DVOLVO]

Should of had it on the back of an OIL BURNER and it wouldnt of happened...

[VT-565]

I'm not so sure, there were two other accidents on the same stretch that day, both were trucks.
There are some pretty dodgy truck drivers these days.

So if you want to be a smart arse, keep it out of my project thread and send me a PM instead.

[21AZI]

wow hell yer

[VKCOMMO]

Sounds like a good project..

That donk is nice

[VT-565]

Run the big block on the JB Automotive engine dyno the other day
Pretty impressive was the 820ft/lb and 1009hp @ 6800rpm
Even more impressive was the fact it performed faultlessly after sitting for 3 years without being started
So now i'll get it home and back in the car, finish setting up the mid plate and weld it out.

[Jonno]

with updated piks?

[HSV5L]

looks TUFF cant wait to see some more progress.

[VT-565]

http://s266.photobucket.com/albums/i...t=645b542b.mp4