Dent Pullers

[Dayvo]

Does anyone know where you can buy a dent puller for pulling out small dents . I'm after the ones that use an adhesive to glue the puller to the dent .
They have them in the USA for about $50.00 but cant seem to find any over here.
Cheers Dave

[davway]

depending on the size of the dent, you can use your windscreen mount from a GPS.
the suction cup is more than strong enough.
the glue ones you have seen are just glue from a hot glue gun - nothing more, nothing less.
some try and claim its special glue but it isnt.
you can buy your own hot glue gun and glue sticks and then use a slide hammer or something similar as the puller - im sure you can think of something to glue on like the "pro" pullers have.
another option is the "pops a dent" system - look it up (ebay/google etc) and make it yourself but make the back bone out of metal (square is more rigid) as the plastic will flex and not work properly.

[Dayvo]

Thanks for the tip . I reckon i could make something up as i already have a hot melt glue gun and some square tubing . All i need is something that will remove the hotmelt from the panel without damaging the paint

[davway]

just roll it back with your finger or use some rubbing alcohol.
check out youtube for hot melt glue dent pullers - youll get some good pro tips from there.

[blaze]

ebay, called "ding king" i bought a set yesterday

[davway]

ebay, called "ding king" i bought a set yesterday

done your homework - well done.
take care when using it as the 2 outer suction cups can also push in the metal while the middle cup pulls the dent.
slow and steady and only do a couple of degree turns at a time (1-2 hours if you think of the twist motion as a clock).
you shouldnt need the knock down tool either but at least they included it.
you can make your own out of some Delrin or a plastic chopping board if you dont have any Delrin.

[Dayvo]

I have seen a few on ebay but i was wondering if anyone like Autobarn sells them.