Search results

That's good to know. I believe it cost me a total of around $1800 when I had the clutch replaced. $1000 for the Exedy HD kit (including flywheel) and $800 for installation. Where in the world can I get a HD clutch kit for only $400? I can barely find OE style clutches for that cost. That's...

So, I currently have an Exedy HD SMF clutch in my 2000 VX. Recently I began hearing a strong springy sound when pressing/depressing the clutch. It was most noticeable when car was off and most audible from the Bell Housing underneath the car. I am assuming that it is the clutch fork...

I ended up doing most of the cooling system when I did mine. Heater tap (which broke when I took the hoses off so had no choice but to replace). Heater inlet pipe (Which also broke off). Water pump (which looked like it had white barnacles growing inside of it and was badly rusted). Radiator...

The OP isn't asking for a hose kit, I only recommended it when he chooses to replace the heater tap. As for the clamps, I guess I can understand. I used the ones that came with the kit and I had to re-tighten them a few times as the hoses got worn in. The genuine ones are self adjusting so would...

Pretty easy. The hardest part is probably getting the hose clamps on. I vaguely remember them being a real b!tch. I think it was a tight space or an awkward angle. If your going to replace the heater tap might as well replace the hoses as well. The hoses that connect to the firewall were the...

I don't think the OP has posted again since their first post. My old neighbour (I say old because they got booted out of their house) used to spin the wheels in his Commodore when taking off. Think it was like a 98 VT wagon or something that didn't have traction control. Rear tyres were bold...

Did you take it for a test drive before purchasing? Did you do the bounce test? Did you visually inspect the suspension when purchasing (eg. Turn wheel to full lock so that you can see the suspension)? If you know how to change suspension yourself just purchase some off eBay and DIY. Will...

Also, when replacing the heater tap make sure that you have the heater set to the hottest setting.

Biggest modification is to probably sell it and buy a V8 like many suggest. Otherwise, do a LOT of searching and reading as there are many threads and advice on these forums and other forums. Get a manual conversion kit and keep it in low gear? Will make your car a lot more fun to...

How does it compare to r134a? I got told it's better than r134a but not as good as r12 (either way it's still good). Anyone want to confirm? I just remember someone saying that I may need a new compressor or something if I was going to use hychill in a r134a system?

I did not think Hychill worked in R134a air conditioning systems? Also doesn't Hychill work really well?

Air-conditioning units are closed systems so it should, technically speaking, never leak or need re-gassing. If it does than it's possible there is a leak which needs to be fixed before applying new gas or else you are likely to just let gas escape into the air (destroying the ozone) and having...

Looks awesome. But I have a question. I drive a manual but it seems all of these are for automatics. I'm having the same problem with finding a triple gauge dash cluster. They are all designed for automatics with the auto gear dials. Do I just ignore these? Maybe just not attach lights to...

Unfortunately not. Worked OK for about a day or two then started stuffing up again on a hot day. I got 4 relays from the wreckers for nothing so got 3 more to try. eBay seem to have genuine Holden relays for about $16 (They look identical to the ones I have). Maybe I should give it a try if the...

Seems the sway bar is meant to be straight. When looking on eBay I seem to see this one for sale and recommended over the genuine part. However it's bent. eBay Link Picture Is there any particular sway bar link people recommend to buy?

I was going to say the ignition system (leads perhaps?). No harm in trying. Just buy a service kit and see how it goes. Holden V6 Commodore VX Major Service KIT | eBay I have no experience with LPG so if it's working perhaps it's not the ignition system.

The guy that wanted $180 said that it would cost $80 just to hook up the gear. LOL. The other 4 places I tried were Holden Service dealers. It included a diagnostics (to see what the problem was) and to reset fault codes. The closer to the CBD the Holden Service dealers were located the cheaper...

Very little actually. We spend about the same amount on clothes and my shoes are considerably more expensive than hers (My work boots are around $200). Seeing as though I hold her bank cards I pretty much have control of her spending. :P EDIT: Although she didn't seem happy with the idea she...

Doesn't seem to have a good rating (59.1%) and it 2013. The link below has a much higher rating (95.2%), is cheaper and 2014. 2014 Top Rated DHL FREE Professional GM tech2 diagnostic tool,Tech 2,Opel SAAB Holden Isuzu Suzuki vetronix GM tech2 scanner-in Code Readers & Scan Tools from...

Recently replaced my seats in my Commodore VX. Forgot to disconnect the battery before taking out the old seats. Wasn't until I put in the new seats and wired everything up that I logged an airbag fault. Seems the car continuously checks to see if the airbag system is working. The moment it...

Too late. Got 4 relays from the local walk-in wreckers. Picked them myself and the guy said I could have them for nothing. So I guess I don't have much to loose even if these relays don't work properly either, or at all. The relays are the exact same as the ones already in my car. If I have any...

All good. Will check to see if the local wreckers are open. Cheers.

Would that be the Blower Relay (As I don't see any high speed fan relays)

My 2000 Commodore VX fan (internal one used for heating/cooling) keeps turning itself off than back on in a repeating cycle when set to HI. When using settings 1, 2 and 3 it works perfectly. When using HI it works perfectly but after a while it will turn itself off. Then after a short while it...

Just run some Nulon Engine Oil Flush before changing the oil and once you have put in fresh oil just throw in a bottle of Nulon Worn Engine Treatment (not just for worn engines but also engines with high kilometres) or alternatively throw in a bottle of Nulon Lifter Free which will help free...

Yeah, check the edit. I found what I was looking for. :)

I am considering replacing all my seats in my Commodore VX S-Pack due to damage and was browsing some seats on eBay and Gumtree. Found some seats that I like from a Calais VT which include door trims for a cheap price and in good condition but I don't know if it will fit my car. The seats are...

I agree with others here. I had, and somewhat still have, this same issue. I replaced spark plugs and leads. Made a massive difference but the issue is still there somewhat. Perhaps I should replace the coil pack as well just to ensure that everything has been overlooked. Are there any...

This is interesting. I'm definitely going to get tie rod ends but presumed that the rack ends came with the package of the steering rack. At least that's what the images on eBay show. Reading through the car workship manual there doesn't seem to be many steps involved. Although I get confused...

So the boot on the right side of my steering rack has completely torn off. It started leaking oil but I continued driving anyway. Now it makes a somewhat clicking noise when turning and is leaking more profusely. I've stopped driving the car since then. Was looking at eBay and new steering...

Had this issue when I first bought the Commodore. Took a few days to figure it out. Turned out the be the indicator switch. It's ever so slightly loose and when indicating right (pushing the switch down) than back up it doesn't seat properly and I get a random clicking sound. Pushing the...

Just thought I'd update. Got the exedy HD clutch installed. There is slightly increased cabin noise when accelerating but this goes away when cruising and is only really audible when everything is quiet. Otherwise if you have the stereo going or something you can't hear it. Clutch is quite...

Why are you paying for damage another person caused? I would be getting your insurance (if your covered) to deal with it or get her insurance company to pay for it.

The oil I bought is API GL5. The gearbox recommends API GL4. However the Diff recommends API GL5 SAE90 which this 75W-85 oil I bought is a preferred substitute for. Can I use it in the diff instead and just buy another proper bottle of transmission fluid? I only ask because the bottle itself...

Yeah still sealed. I guess the transmission is a lot more sensitive to the type of oil used than what the engine it.

Went to buy some Penrite Full Synthetic 75W-85 but all the auto shops I went to didn't stock them and had to order them in. I didn't want to do this so settled for the Nulon variant and forgot which oil to get and ended up buying 75W-90 instead (An alternative to SAE90). Should I take it back...

If it hasn't been said yet, a good mod might be a manual conversion if your license allows you to drive one. Much more fun to drive than an auto and can help improve performance, acceleration and fuel economy if you know how to drive properly. If your only looking for cosmetic mods such as...

Yeah. I was planning on doing it myself until I realised I will be by myself. Reading the car manual and having a look under the car I didn't think I could do the job without another person's help. Got a quote for $400 labour. Seems to be the cheapest price I got and am happy with it. Booked...

Did you have a mechanic put it in for you? If so what was the labour costs? I'm still tossing up between doing it myself or getting a mechanic do it for me. Problem with doing it myself is that I will literally be doing it myself (no help from others) which will make things a lot more...

Just bought myself an Exedy Heavy Duty Clutch Kit with flywheel. Came with spigot bearing, pivot ball and alignment tool. Cost me $999 from autobahn. Have been quotes $450 manual labour costs if I supply the clutch kit and rear main seal back plate and other parts (eg fluids). May be cheaper...