Search results

yeah not looking to bag the ute guys, i dont have the coin for that.. thanks mpower mate that was the info i was after. get a good few cm lift in the back ay? think ill be going with the gas risers diysv6 mentioned.

and while im here. metho/methylated/water cold air intake from the window washer reservoir.. good or bad idea? :idea3:

picture related..

Gday folks. looked around for info about air shocks but couldnt find what i needed so making a new thread. looking to lower my sv6 similar to in the pic (will post next). was wondering if putting air shocks in the back would allow the back to be pumped up enough for bikes in the...

bump because still curious.

Gday folks, so recently i have discovered that after stalling my sv6, turning her over again and driving off, she gets louder than a priest on a sunday. i have no idea what causes this but it sounds sick (nice and loud) for a while then goes back to normal.. i have the stock exhaust with no...

Hey Fellas, Ive put a set of vz ssv 18inch rims on my vs and i only had the stock lug nuts to put them on.. my question is, should i be getting proper nuts for them? will the stock nuts cause stress to the wheel or something? and if i do have to get some new ones, where could i get the right...

Hey fellas, just a quick question for those with more experience. a vy supercharged v6 auto with a blown head gasket, is it better to fix the motor or replace with a recon motor (most likely not supercharged though..) how much approx would i be looking at to get it fixed by a professional vs...

yeah changing gears fine just the big loud rattle thats causing the vibration in the stick and pedal so im assuming it is the input main shaft bearing, but idk how difficult that is to replace

its a conversion, he reckons the heavy duty clutch he put on has put stress on it and caused it to break..

nah.. its a constant rattle, and gets worse when slowing down and only disappears when idling

its not my car its one im looking at buying, the owner says its input main shaft bearing but as far as i know the whole box could be one its way out..

nah mate still loud as with the clutch in, it dies down a little cause of no revs but its still making a big clunky noise

Hey Guys, Basically theres a big lumpy rattle sound coming from under the dash/gearbox somewhere, i can feel the vibrations in the stick and on the clutch pedal. when the car idols there is no noise but as soon as you pick the revs up its loud as, but if you put you foot down further it...

nice rig mate. where did you get the body kit to fit vz from?