Search results

notice you have changes the vacuum hose when installing an oil catch can. much cheaper than buying the original vac line from Holden. wd.

agreed reaper, was just kidding around.

this thread was for adventra vehicles if not mistaken. yes they are AWD, this is why economy is isnt as good as its standard equal. an Adventra without AWD would be Adventraless....

the exaust has been changed from a single to a twin muffler system. on the left hand rear muffler has no mounts. im going to buy a new mount and heat shield for that side. on the diff mount there is another muffler pipe mount, problem is theres only a mount for the right hand side and no where t...

fyi the front diff is a higher ratio than the rear. the diff limits the fuel economy saving some what.

my 2 cents - if you see a fuel truck parked at the servo, go to the next servo or wait a day or so. fuel entering the servo tank from the truck will stir up crap in their tanks.

wow man. the wear on the shaft.....is there a shudder through the car or when u touch the gear shifter showing some kind of imbalance?

5speed has no dip stick. u need to undo the filler point to check

depends how much your car is worth, and not at a car yard.

looks like a top product. its on my wish list.:beer chug:

whatever you buy, buy it in the 20lt it works out heaps cheaper in the long run.

i think tech 2 could adjust this. my gauge is about 50lt on a 75 litre tank. so it seems to run out early. because i know this i can drive up to 150km while the needle is below empty.

always leave the cut process to the experts, scratch and swirl by McGuires is the best only on problem areas. wax wax wax wax and more wax. McGuires are best.

Perhaps a new plug for a few bucks will be good too Sent from my GT-I9300 using Tapatalk

Safety safety safety. Louder may be ok also consider about reliability and making sure everything is up to scratch. Sent from my GT-I9300 using Tapatalk

omfg it was the spatial occupier.........

that lasts about 3 secs and u get bored of using it.

how many k's has your car done?

Perhaps down to holden for a new key fob..... Sent from my GT-I9300 using Tapatalk

Colder days will be more efficient than warmer days Sent from my GT-I9300 using Tapatalk

Could be the pim bcm ecm need tech2 hooked up perhaps Sent from my GT-I9300 using Tapatalk

Coils n plugs.... Sent from my GT-I9300 using Tapatalk

I'm still a little stumped as to how the air pump affects your steering position sensor and the fuel signal..... Sent from my GT-I9300 using Tapatalk

update. when i purchased the vehicle the level air ride pump was disconnected, stopping the pump from burning out because the air-bags on the shocks look like they have had it. bit the bullet to find out why esp failed was appearing. Holden said ''codes P1632 C0460 relating to the...

those motors are hard to start sometimes, trying to hold down the key to start for longer periods. air-box wont affect the start unless there's a blockage. it also needs petrol to run.

ok. the radiator holds the water. u need to replace this. the radiator support needs replacement and best done and checked over by qualified persons. if its just the motor u want than u still need to start with the radiator problem.

too funny....ROFLMAO:rofl2:

check previous threads which detail this procedure. the relay location is in the bcm.

McGuiars are top products

depends if you have it loaded or not. mine runs way smoother and controls better with weight on board.

bird shyt?

do you think its just body roll? shocks maybe shotty.

the book says 5w-30. end of story.

use vice grips.... normally u undo this prior to undoing the mount bolts

i used to own a camira, i rebuilt this motor and know its the worst ever Holden put in one of its vehicles )

howd ya go?

pays to change the plug every other oil change to renew the rubber seal.

correct adventra engine sump is different to the standard vz's. you are trying to undo the right plug. make sure u turn it to the left(noob ? i know...) also try using AF spanner. it may be better fit. if all else fails use vice-grips or small set of stilsens. replace plug they cost bugger all.

Would my abs affect my esp? Perhaps my bcm is losing connection with the abs creating an esp error? Sent from my GT-I9300 using Tapatalk

Find a new dealer. Any holden questions are likely better answered here. Sent from my GT-I9300 using Tapatalk