Search results

Hey guys just stuffing around with the commy and have a b&m electronic shift plus and was guna put it in the only problem is that instructions that come with it the wire colours are different to what I have in wiring loom so was just wondering if any of you guys know which wires I splice into to...

Hey pythons sorry didn't get back to you sooner I have done the full climate control with loom to my l67 spac with full bcm,ecu and keys from one car and work straight up. Now with getting the main loom through the firewall will be your next problem man its tight you can get but can risk...

hey pythons I would stay away from that gree/white wire as that wire is a serial bus communication wire which communicates from ecu, bcm, climate control , dash etc. If you start messing around with that wire could cause problems as that green/white communicates through that wire and could play...

also forgot to mention is the key reader on right if its out and the key dont make contact can give you that outcome but remember the bcm ,ecu and keys have to be from same car cant just swap ecu as mine did the same thing when I did a swap from my l67 to n/a put the ecu I got with the n/a and...

hey, I believe there is could be a few different wires there but it also depends on what you pulled your engine loom out of, was it a vt s pac or berlina/Calais or executive and was yours a vt and what series. lets just say you pulled your loom out of a spac or executive I cant see why you have...

I second what accent said or the programming of the keys hasn't worked ,also have they tried and stuffed around with bcm when trying to knock it off.

Hey guys, Charged I wish it was that easy but it has a new fuel pump in it as I had a hesitation between 1500 -2000 rpm which was the pump, I did the l67 bottom end nearly 3 years ago so just put in a n/a in her to get her going again and 3 months ago she decided to do a valve spring and drop...

Hey guys ,been a while since ive been on here ,and lately I have been getting hard start in the morning at the start then become everytime the car sat for over hr and had a bad misfire at idle. Well with hours of diagnosing the fuel system to see if that was the issue which it wasn't all in...

Hey you still have transmission what would you take for that.

also check your ground to your motor an dbody clean them and see what you get i had same problem when my ground on motor come lose causing the fans to come on when not hot and stay on if the ground is lose or corroded the sensor will tell lies ,also could be the temp sensor for thermo fans or...

check the grounds to the body and engine mine did this fans come on for no reason wouldnt turn off sometimes ended up being the ground to the motor was lose there fore all sensor where telling lies etc.

Check the ground points to body and engine .

Hi there is it the holden anti theft maybe there is problems with that and does the old key still work try that. When they coded it did they use your old key to do it as they need your old key to get it right i have heard a couple of stories where they have stuffed them up and also when you put...

anti theft Hi there i know it frustrating but it will be somthing really simple. I m still thinking anti theft is the culprit. You say you have new keys why did you get new keys and where did you get the head coded for them and did you link them to the car there is a special combo you need to...

Did he tell you the method of using the new key. Been a while since i had to do this but i think it was somthing like open the door with the old keys put new keys in the ignition turn the key to light come on dash and wait for 30 secs and then it should start the car if that not right google or...

I think you might have a fault with your climate control module not 100% on that as its been a while since ive been on here but i know the x on the dash and module is a fault. are both fans running or just the one.

Could be alternator on its way out

Hey there have you played with the plastic around steering wheel where the contact on key meets on the barrel if the little knob on your key is not touching it wont start also have you changed bcm, ecu etc seem very weird it wont start you have basically replaced everthing get back to us so we...

Hey there what ar eyou exactly wanting to know how to remove dash or pull climate control module apart let me know either way its easy.

i think if you press code 1111 it allows you to use it for 3 or 4 mins annoying but that works.

or you could just go a after market kit from supershit or autobarn etc.

hey guy as accent said you will have to go to a high bcm as only high bcm does that and you will also need the sensor . Also just for the record the lux bcm wont do auto headlights either which is in the berlina only calais have high bcm. But saying all this aswell you cant just swap the bcm if...

hey guys as mentioned above the green film is easier than you think to remove i used nail polish remover or thinners will do it and just rub the film of where all the numbers are and where it lights up no need to remove all of it just where dash lights up i taped it up when i did mine.

hey clown you will need a high bcm for those lights to work i believe.

i have a couple here if u wana buy one send me pm if interested

send me ur email i have diag with the globes that need to be changed

hey krausey i agree with cameron you will need a hotdog for sound i have super 6 exhaust on mine as i was charged but done the bottom end so put standard ecotec in and it just has a deeper sound to it nothign to brag about so if your after a more lumpy sound swap the resi with hotdogs.

hey guys lookign to supercharge a standard ecotoec Hey guys sorry to reply in quote but it wont allow me to reply for some reason, if your wanting to supercharge stock ecotec go to l67torque there is plenty of guys on there that have done the swap to standard motors and running fine ,one...

hey curtis well you know the colours thats right , they are located on bcm connector 1 ,what i did is i untapped the wiring that goes to bcm connector then i cut the green/black and the green/orange and left a good inch of wiring left to the bcm connector incase i wanted to rectify the bypass...

Hi again with the ecu they are the same as the standard v6 its just the chip that changes as the tune is different so as i said before if your gune do electric windows swap the ecu,bcm and keyhead over and you wont have to get anything link but if you just wanted to get it running for now just...

Hey there with the ecu you can either swap the chip or if your guna do the electric windows etc you will have to swap the the bcm as yours will be a low bcm and you need a med bcm for electric windows so i would swap the bcm,ecu and keyhead out of wreck and your window will work with out...

Hey guys well it snot that hard ,just go to l67 torque a few guys on there have done the swaps 2 l36 and running hi boost and wou will have to swap the whole top end over heads, exhaust manifolds ,and engine loom with the ecu you dont have to swap your ecu as the l36 and l67 run the same ecu...

Hey there guy dash lights are t5 wedge but u will find that when u plug them in they actually flare the the plastic seat for them and makes it hard to get back in so i filled my down a bit to get them in and the trip light are t4 neo wedge globe ,jaycar do have them that where i get myn but they...

seats wiring Hey guys here a diagram for eletcric seats.

Hey guys i have heaps of diags email me if you need them on [email protected] i would add the to this i just dont know how to.

He there guys i have done elec windows on my vt and was easy as i did the bcm bypass i have the diagrams if you want to know what wires to cut and join . email me if you wont them on [email protected] cheers

Hi there so is your led turning off when you try to start it , and i take it your lcd screen isnt switch from klms to instants etc , mmmmm sounds interesting ,just guessing maybe your key barrel is worn, bcm is nackered. Have you bridge the diag connector to see if any codes have been spat out...

Hi michael just wondering if your any good at hacking programs i have found this program on the net from coda, dont know if you have heard of it ,its a pc based scantool that suppose to do 95% of what tech 2 can do you can download the simulation mode but you have to buy it to get the unlock...

Hey guys no shouldnt be a problem as there is only +,- power runnng to the seats so it should be a straight swap thats what my pdf is telling me anyway ,and the passenger should be the same plug as drivers just have to get one and wire it up to the drivers seat for power.

Hey there you will hav e to bypass the bcm so your window will go down everthing else will be just plug and play but you will find that yoru drivers window wont go down, so you have to bypass the bcm for it to go down email [email protected] and ill send you some info on what wires to bypass.