Search results

No its not legal

Main thing is you keep up with servicing I get mine done every 5000klm

I had the same issue years ago in my VZ & it ended up being a bad earth in the tow bar wiring

What issues are you having with your Monaro, just curious

Your inlet manifold is rooted, needs changing & the whole system flushed out

Depends if you want to pull it up, Id be swapping over to discs

Stabilizer bush stuffed I'd say at a guess

Did you have it in "R" for race mode

check heater taps as mentioned & could be leaking around water pump

may as well throw in a new set of coil packs, see if that helps

Just saw this.. Hi everyone, this is my first post after following the site for awhile because my vz v6 developed a miss. Long story short it end up being a short in No.6 INJ circuit, it was going to cost me $900+ for the ecu and $200+ to configure it :/ Being a mechanic myself I looked into...

What no vinyl bugger

I'm addicted to both Ray Donovan just started screening series 4 & Vinyl just waiting for series 2 to hurry up & come back.. Both Excellent shows

There's no give in the tyres side wall with big wheels & small low profile tyres, I'm sure you will be getting a few more over the years.

S2 VT had clear blinkers..I don't think they came out on the VS though.. Common Mod

Probably one of the coil packs has **** itself

Start it up & drive off within a few minutes.. Drive normal no rush to get to work

VK BLUE MEANIE & LJ GTR XU1..2 will do not greedy

The Berlina models have a chrome one available, so no respray required if you like chrome

I think they call the paint Shadow Chrome

I just learnt the other day that when you push the switch in it stays open when you turn your ignition off

I wouldn't even bother with a $100 wrecker job, only will end up stuffing up & your back to square one. For the $430 price difference get new with 12 months warranty

Oils Ain't Oils Sole.. If anyone is older enough to remember this ad on TV

Cheers Tim

Can you dig out link to ebay for the part Cheers

Normally reverse starts to slip first , then 4th.. You still might get a few more miles out of her..

It's rooted

Gone back to Korea as a square block of steel, to make new Hyundais

I have been told best to replace lifters & cam @ 100k as a prevention, apparently the lifters let the 6litre down before anything else..

Not sure if your on Facebook but there are a few VE type sites...But FB might get a bit more coverage than JC & get you results..

Have you got a tow bar fitted could be a bad earth somewhere in the wiring, had a few issues with my car when I bought it & turned out to be tow bar wiring

Western Suburbs of Sydney not far from Penrith...why your in SA a bit for a bit of trimming

Any seat trimmers on here who can give my worn out VZ Acclaim drivers seat a bit of TLC I will post pictures direct to you & show you the extent of damage I need fixing Located In Western Suburbs Sydney prefer a local bloke.. Cheers Trevor

Have you tried changing your radiator cap

Replace the Crank Angle Sensor, you have nothing to loose you have changed everything else

It must be a problem with the door lock activator

You got nothing to loose, I have used Chemiweld with success as well a few years back..

Very nice car except for the tow bar hanging out But I suppose that's for towing your yacht around..

Farm Truck is now out of the top ten

Hope your not using E10 rubbish