355 new build , MLS head gaskets ?

[shane_3800]

Good news , well I think so anyway, calc says 10.14: 1 .
Got bearing clearances all measured and crank installed. I had to fit up a piston and see where it sat, 15 thousandth's down the hole giving 10.14 to 1 CR as per calculator , that's with 40 thousandth's Felpro head gasket compressed figure and 5cc valve relief flat tops.
That will do me !
Thanks for help/info/ideas .

It'll be close to that unless you used a deck bridge, but close is good enough for your application.
So good outcome .