Roto-Fab intake for VE SIDI SV6

[VS_Pete]

Hi Mace,
Will we see a Roto-Fab type intake from Mace?
With a lid?

https://www.roto-fab.com/2010-15-camaro-v6-cold-air-intake.

Cheers Pete.

 

[kuzman89]

An OTR would be much better in terms of performance.

 

[VS_Pete]

I like the pod.
Had otr and then mace pod on the vs I prefer the pod.

 

[commodore665]

This my Mace intake with the lid removed , which is kept aside and clean , I used boot rubber to seal the edge of the Mace one , so I can swap them back when I wan't too , does it work , well meh , maybe in my mind it does , but you get the picture .

 

[VS_Pete]

Is that the vs one?

 

[commodore665]

Is that the vs one?

No , for the VZ Alloytec

 

[VS_Pete]

So that will fit my VE?
And do I need the fillin panel (I think it`s called)

 

[commodore665]

If you get the Mace CAI for the VE , what I did was , get some rubber door,or boot seal , and that slots over the lip of the intake , unsure on the fill in panel though , I didn't bother .

 

[VS_Pete]

The panel you have that is around the windscreen washer filler the yellow cap and goes over to drivers side.

 

[commodore665]

The panel you have that is around the windscreen washer filler the yellow cap and goes over to drivers side.

ah gotcha , I used the radiator shroud , on the VZ CAI the lid has no provision for that , as the windscreen filler is on the other side , and the shroud covers the radiator surge tank / dipstick tube as seen in my original pic