Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Tips on removing engine and transmission

Discussion in 'General' started by Shounak, Dec 5, 2007.

  1. Shounak

    Shounak The Kicking Horse

    Messages:
    2,499
    Likes Received:
    58
    Trophy Points:
    0
    Joined:
    Apr 20, 2005
    Location:
    Vic
    Members Ride:
    VX Executive S2 + XF Panel Van Project
    I need to remove the engine and transmission from the ole project car.

    Can I remove these together as one big part? My initial plan was to drop the tranny from the bottom, wheel it out and then take out the engine using the crane.

    But apparently it's much easier to remove them both together using the engine hoist.

    After disconnecting the tailshaft and all the appropriate engine connections (hoses, lines, etc), is there anything else I need to be aware of?

    Do I need to take off the bonnet? How should I have my helper help me whilst I'm jacking the thing up?

    Anything else? I haven't attempted anything of this scale before and neither has my friend. So any advice at all would be appreciated.

    Cheers
     
  2. Morton

    Morton For external use only

    Messages:
    4,097
    Likes Received:
    83
    Trophy Points:
    0
    Joined:
    May 20, 2006
    Location:
    Melbourne
    Members Ride:
    Fairstar the Funship
    Yeah, you'll need to take the bonnet off to get the crane in over the engine at the right angle. It's also a good idea to have at least two people there if you intend on taking the engine + trans out as one piece. When I did an engine + trans swap on an old VN, we had four people working on it solid to get the stuff swapped over in time. It's a little bit of a pain to get the whole assembly back in straight on the engine mounts, but yeah... removal, not too big a jig.
     
  3. Shounak

    Shounak The Kicking Horse

    Messages:
    2,499
    Likes Received:
    58
    Trophy Points:
    0
    Joined:
    Apr 20, 2005
    Location:
    Vic
    Members Ride:
    VX Executive S2 + XF Panel Van Project
    Cheers Morton,

    Has anyone used an engine lift plate before? The X-Flow XF has a 2 barrell carb and it seems much easier to put a lift plate in, than the other options.
     
  4. Sabbath'

    Sabbath' Road Boss

    Messages:
    5,352
    Likes Received:
    67
    Trophy Points:
    48
    Joined:
    Jul 3, 2006
    Location:
    Vic
    Members Ride:
    80 Series// MK5 GTi// HZ Tonner//Road Boss
    Ey man, if you need a spare set of hands give me a yell
     
  5. Morton

    Morton For external use only

    Messages:
    4,097
    Likes Received:
    83
    Trophy Points:
    0
    Joined:
    May 20, 2006
    Location:
    Melbourne
    Members Ride:
    Fairstar the Funship
    I assume you just intent to bolt the lift plate onto the intake, shounak? It's a good idea if the lift plate fits perfectly... and if you think the intake can support the weight of the engine AND gearbox.
     

Share This Page