Vs manual loom problems

[Tarcs]

Hey everyone new to the page but hoping I can get somewhere with my car as it’s just been manual swapped with a auto loom ecu and bcm but I’ve got a manual chip in a auto ecu. But it ran in the previous car with a auto ecu etc and a chip but now I’ve put it in this car and I’ve bridged the starter it turns over but will not fire as it’s not getting any power to the injectors? And won’t turn over from the key but the dash lights will come on? Anyone have any suggestions really appreciate it

 

[gtrboyy]

You using previous memcal,bcm & keyfob all from same car or just ecu/memcal....if so you'll need vats turned off.

Check fault codes it will probably come up.