Haltech E6GMX tuning Question

[wez84]

Hi I have a buick style v6 in my commodore with a 6 throttle body manifold
I was wondering if the E6GMX can be tuned with out a Map sensor

[Pub247]

what were you plannign on using instead of map sensor. AFAIK they can be used with either map of MAF based i doubt you could run it without either.

I'd say it wouldnt be an issue using map sensor you might get away with running it off 1 TB otherwise you may have to hook them all in a paralell setup or something

Emailing haltech might be the best way to get your answer

[wez84]

Cheers i know it can be done with other aftermarket ecu.
I was just throwing the question out to see if anyone here would know and if I have to buy a different ecu.

[jayperformance]

You can switch to inboard map sensor, possible to turnoff completly..

[limited cv8r]

Pretty sure you can run Map or TPS.

[gts_215i]

Page 27 of the manual - Haltech – Engine Management Systems » Previous Products

Load Sensing

The ECU can use either the manifold pressure or the throttle position as a means of
determining the engine load. Most engines operate using manifold pressure to sense
engine load. If your engine employs any form of supercharging, you must run in
manifold pressure mode. Only engine with long duration cams or multiple throttle
bodies or motorbikes require throttle mode - i.e. Engines whose vacuum signal is
small, or fluctuates greatly.

[wez84]

Cheers guys Thanks for the replys

[NOT 38]

put up a pic of ur manifold :P