CRS Supercharger small pulley belt

commodore · #1 26-01-2006, 10:38 AM

Hi Guys, newbie to this forum
I have just purchased a small Pulley and front TB manifold from CRS, it's an ecotec V6.
The new belt is to long from the original large pulley setup even with the tensioner which
gives me a slack belt. It has air which is standard on VS and later models. CRS told me to use original N/A belt but that is way to small. Does anyone know the correct serpentine belt to use for the small pulley setup(any suggestions) as I want to get it going ASAP. also any suggestions on water injection to cool intake air would be great.
VS Manual commodore
lowered and pedders shocks
6 speaker and 12" sub
pioneer head and 6 stack
mags
3" exhaust cat back
CRS standard S/C ATM at 2psi
cheers

IBLOWN · #2 26-01-2006, 06:37 PM

i bypassed my aircon compressor and used the standard belt until i ripped out the aircon. click on my link below for some ideas.

Tradewind · #3 27-01-2006, 06:52 AM

Bud you need a mate or two for a job like this

Need tape measure to act like belt and go perfectly around all pulleys, a mate has to wind the tensioner up for you as well, then just read the measurement of tape length. So if you get measurement like 2960, then you are looking for a 6PK2690 belt. Now you got all that figured head out to a see a belt and bearing shop to order/purchase your needed rubber band

commodore · #4 27-01-2006, 09:41 AM

Thanks Tradewind, Thought about that but didnt know you could get exact belt sizes
will go to Mundys and get one after measuring. Do you know of any water injection setups or a good way of making one, thinking of making one using washer bottle and washer moter with pressure valve to turn on around 3psi and putting a jet into inlet but dont know the jet size to use have to experiment I suppose
thanks for info
cheers