vb tune

[ab56452001]

hi ,helping a mate to get his 3.3 vb commy running again , need to know dwell angle / timing/points gap , got it to run but wont idle , sounds like a low rev miss ! ,could also be a carb prob or sucking in air in inlet manifold ? , anyhow were these motors the same as the original 202 hq motors , or did the specs change over time ? , thanks for any help.........

[vkberlina]

hi ,helping a mate to get his 3.3 vb commy running again , need to know dwell angle / timing/points gap , got it to run but wont idle , sounds like a low rev miss ! ,could also be a carb prob or sucking in air in inlet manifold ? , anyhow were these motors the same as the original 202 hq motors , or did the specs change over time ? , thanks for any help.........

Plug gap 1mm
points 0.5mm approx (according to the original VB servicemans guide yup it says approx after it)
dwell angle 30/35 deg
condenser .15/.20MFD

timing 6deg BDDC below 900RPM

cheers
Scott