VS elec windows into VK. Can it be done?

[seq4x4]

Iv been doing some research for awhile to put my VS elec window set up in the VK. Basically what iv learnt is that the VS set up goes into a LX torrie and their also similar to the VL. Saying that VK and VL are simular.

So from my basic understanding the fronts have no problems going in. Its the rears i could not figure out!

Would anyone have any info or know anyone that has done it to shed some light? Because if it could be done im keen to do it

Cheers in advance.

[vkberlina]

I would think the VS ones wouldnt fit the front as the doors look bigger on the VR/VS, you would need to measure up the doors and see if they would fit, as for the rears check the travel height and if the same it should be able to be done the rears are a bitch with the wire cable looping all through the doors, I will never pull mine out again.

Propably with a bit of fiddling and adapting they would be able to be fitted but why not just use the factory VB-VL ones that would just bolt in?

scott

[seq4x4]

Cheers for the info scott. Im aware of it being a hard time, but being summer i like atleast from front windows down and leaning over to do the passenger side can be painful at times.

The reason im using the VS ones is because im wrecking my VS. The elec window set up is near imac and instead of going out to buy some used possibly stuff set ups i have my VS ones still in the car.

Im thinking i may have to buy a front and rear door and do the test fits on them. But theres no point in going to all the trouble if they dont even want to fit in the first place.

[Krisp]

i think its pretty close with the front mechs from memory just go on egay and compare visually