VE custom gauges

[OMEGA07]

hey guys I've got a 2007 omega and was going to do a gauge install into the unused part of the centre dash

I've seen kits on eBay and a few good looking gauges to match the interior stock ones but thought I'd ask which gauges u guys recommend?

Plus what's the best way to install an oil pressure gauge to the alloytec in the omega?

Thanks guys

[IGNITIONSV6]

ive done it its easy look at my link in signature.....you biggest problem is gunna be omega is green at night yeah....so you will need to find some green gauges not red like i got

[Lumps of cheese]

I'm going the JHP kit. Bit more expensive but they look the part and use genuine parts.

[SV6.07]

Dash gauge install progress

[OMEGA07]

ignition that setup looks unreal mate!!
pictures look a little confusing though haha is it a job for the pros?
im just struggling with the wiring from the cabin to the engine bay in terms of connections nd wiring points

[IGNITIONSV6]

Yeah the pics don't do justice...you don't need to be a pro just be patient with it...it looks like the dash is in a lot of pieces but its actually only like 6 or 7 bits i think...i did it properly so wires didn't dangle down and look shit that's why i had to go in deeper lol

[bonners]

I have Aeroforce Interceptor Scan Gauges.

Aeroforce Technology Inc | Welcome

These dont need to be wired into anything. Its a simple lead that plugs into the OBD port. I used a SS Inductions pod like Ignition's.

Basically, you mount the gauges in the pod and run the cable along the front of the dash under the two pieces of trim. The you run it on the inside of the trim on the right side of the dash until it pops out near the bonnet release. Then you plug it in.

Can be set to read hundreds od different parameters including fault codes.

Can even get it in green to match the Omega



and come in other colours as well.
Aeroforce Technology Inc | Project Vehicles

Downside...... $400 for two gauges....

[calais06]

Do any of these Pod Dash mounts fit the Calais?

[bonners]

I believe the centre speaker is the same on all models. That means that either the JHP or SS Inductions one should fit.

I'm on my phone writing this but search eBay item number 120750969904

It says for all models.

[dredrum]

Thanks for sharing that link bonners..them gauges are tits, and can even get them the right colour to match my Calais interior lighting!!

[calais06]

Thanks mate,

I looked at one on ebay yesterday and it said non-calais
"produced by SS Inductions to suit all Holden VE models except Calais."

Anyone know of one that would fit the Calais, or lives near Wollongong so I can compare them lol? :P

[bonners]

No worries.

As I said, downside is cost. But getting two autometer gauges installed professionally would cost more. And these do so much more.

[dredrum]

Exactly...the list of Functions is near endless...and you don't need a auto elecy to wire em up, so easily worth $400