Tutorial.

[vlteclol]

Would anyone have a guide video/pictures of how I would change my RHS headlights of my Holden Berlina VL. Had another car reverse into it. Where would I start ? Thanks.

[Skidney]

Just open your boot mate and there should be some pretty obvious screws to remove, then it should just pop out.

cheers

[vlteclol]

I was referring to the front (bonet), wasn't sure which screws I'm meant to remove. Didn't want to take out the wrong screws and not be able to put it back, lols.

[Sabbath']

Pretty sure you have to take the trim strip off to get the two lower scres, then there are two screws on the top.

[Goon]

not that hard, just look whats holding them in..should just be 2 screws on top.. i doubt theres any under the bumber holding them.

[Nackerz]

yeah there is four all up as i just pulled mine out the other day just before he posted this up

[vlteclol]

Hrms, since only my lense, well outside glass (clear) part got smashed, would I have to replace the entire head light, or could I just change the lense ? It seems to be clipped on, am I right ?

[Nackerz]

you could but eaiser to replace the whole thing mate

[VL Berlina 5speed]

remove bar first - 4 bolts on side of rail under the car - 2 bolts from under inside under the guard to the bar ends,

remove grill - 2 screws from the front in then bottom grill slot

remove side upper bar moulds - screw in end of mounld to guard - bolt from under headlight panel too mould - then squeeze some clips and will remove side ways of car

center mould - using flat head screw driver pop off clips near middle and remove mould


to bolts for head light are accesed from openings on top with the bonnet open
and two are located under the head light

un plug loom and your done