legal springs

[dobbie]

i am lowering my vl with king springs super lows r they street legal

[mag]

Hi in my state no so check with your motor reg dept.
and check your insurance company..

[dobbie]

no insurer wat state u from

[mag]

no insurer wat state u from

I'm in S.A.

[dobbie]

any1 else no wat the go in qld is?

[JBVL]

the lowest point needs to be 100mm or more off the ground.
if you get pulled up they will roll a little wheel under your car and if it hits anywhere, they know your too low. In QLD that is.

[dobbie]

should b right 2 go

[fitzy2005]

your fine, ultra lows are legal if you haev no kits on aparently, so you should be right

[My Car Pwns]

im melb, they usually test it with a coke can.. looks funny as hell...

[mattman]

You do know a coke can is more than 10cm tall?

In all states it is the same - must be 10cm clearance, watch those big mufflers

[VL Berlina 5speed]

You do know a coke can is more than 10cm tall?

In all states it is the same - must be 10cm clearance, watch those big mufflers

thought it was meausered from the center of ur wheel hub to the guard.

When lowering a vehicle body, either front or rear, the limiting factor is the clearance between the rubber bump
stop and the corresponding metal stop. This dimension must not be reduced by more than one third of that
specified by the manufacturer.

this is a part out of the transport sa guides and regulations

[bbad13]

You do know a coke can is more than 10cm tall?

In all states it is the same - must be 10cm clearance, watch those big mufflers

mufflers what the hell are they???? lmao :P

[dobbie]

anyway got them done makes a big diffrence as far as looks go asked the guy that did them he said their not legal but another mob said they were so i spose it all comes down to the cop thet pulls me ova lol

[VL Berlina 5speed]

got any pics? because ive got lows on mine and im thinking going 2 superlows just want to know what it looks like and what is the distance from the centre of the hub to the guards edge (at the top, centre)

cheers

[dobbie]

I just got it done so not as yet n ive lost my camera somewhere around the house but i can send u a mms if ya want

[VL Berlina 5speed]

nah dont worry bout ti then but could you measure the distance from the center of the hubs to teh guard, as i wanna know if it would pass the legalness in sa, plz ill be very gratfull if u did

[dobbie]

just measure yours n ad an inch super lows r 2inch n lows r 1inch

[VL Berlina 5speed]

cheers, i could find the differace between lows, superlows and ultras but cheers 4 taht