Vp wiper motor keeps snapping off bracket??

[Wagon_Wheel]

Hey guys. Had my wiper motor snap itself off the bracket not long, so I replaced it last week with one I got from the wreckers. I got the whole motor and bracket and everything and swapped it over. Drove it last night in the rain and it snapped again. The wipers did chatter a bit but didn't think anything of it.
Has anyone had this before?
Anyone know how I can fix this issue?
Cheers
Geoff

[vsl67]

I had this happen in my VP it was caused by the mounting bolts working their way loose so check if your bolts are stripped or try loctiting them in

[greenfoam]

I've had the alloy arms snap off my old VN, but not the bracket. Apparently the VS one can be used and is better?

[Wagon_Wheel]

Is the wiring plug the same on the vs ones?
The bolts holding the motor on were not loose at all.

[Brad S15]

Just replaced the wiper motor and linkages in my VP after the linkages jammed and the motor kept turning and instead shattered the cast wiper motor gearbox housing. Grabbed a whole assembly from a VS commo at the wreckers, turns out the plug connecting the motor to the car's loom is different (its still 5 wires but its in a different plastic connector) so I just made up 5 little jumper cables and crimped them to the correct wires and then plugged them into the old connector from the VP which matched the connector on my VP's firewall