Results 1 to 4 of 4

Thread: differences in tail shafts

  1. #1

    Join Date
    Aug 2006
    Posts
    68

    Default differences in tail shafts

    just wondering if there is any difference between a wagon and sedan tail shaft

  2. #2
    Ride
    S/C VN, VY SS, Waverunner GP1200

    Join Date
    Dec 2005
    Location
    S.A
    Posts
    324

  3. #3

    Join Date
    Jun 2006
    Location
    Western Aus.
    Posts
    281

    Default

    Yes but only in the rear section of the tail shaft.

    From the centre bearing forward is the same (only difference there is between auto/manual)

    The section bolted to the back of the centre bearing, wagon is longer then sedan.
    Hot Lap Motorsport

  4. #4

    Join Date
    Aug 2006
    Posts
    68

    Default

    cheers so if converting a vb to v6 i should use a front of a vn and the rear off the vb

Similar Threads

  1. Will vt v6 rear shafts fit?
    By Sharpie in forum VR - VS Holden Commodore (1993 - 1997)
    Replies: 1
    Last Post: 21-09-2010, 09:27 PM
  2. Any Recommendations On High Power Handling Tail-Shafts..??
    By QuickVRII95 in forum VR - VS Holden Commodore (1993 - 1997)
    Replies: 142
    Last Post: 16-09-2010, 12:43 PM
  3. CV Shafts
    By VYruckus in forum VY Holden Commodore (2002 - 2004)
    Replies: 0
    Last Post: 28-05-2010, 09:57 PM
  4. any other shifters shafts fit t5
    By beefcream in forum General
    Replies: 1
    Last Post: 04-07-2009, 05:30 AM
  5. Trimatic & M20/21 tail shafts
    By craigvk in forum VB - VK Holden Commodore (1978 - 1985)
    Replies: 4
    Last Post: 07-11-2006, 03:44 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72