VP gearbox speedo sensor?

[kid_720datto]

Hey guys, a mate has asked me to get a part for his berlina (unsure of year) as he lives near no parts
Shops himself. Any way he has told me it's a gearbox speedo sensor or sender. He says it has to be that cause he replaced the speedo gauge and it's stil not working. I rang supercheap and they told me the gearbox doesn't have any sensors that they could find, the only speedo sensor is on the engine.

Should I try a wrecker to see if they have a clue? Wat else could be stopping the speedo. I thought it ran off the back wheels

[Cheap6]

The sensor will be there, a little black cylinder that screws onto the back of the trans. with one white connector.

Not the sensor? Wiring between the ECM, the sensor and the gauge.

[hi_ryder]

its at the back of the transmission and will have a plug hanging off it... where the drive shaft meets the extension housing seal (that area)...

edit: yeah what he said...

[defecat0r]

Hey i was under the car a weekend or two ago and happened to take a photo of mine. It's leaking oil, i think there must be an o-ring or something that's stuffed on it. So if u can see through the muck and grot and grease and piss that's it
it's on the drivers side a far way back from the engine. Mine's a manual, dunn if that makes a difference

[mr calais 5.0]

You will find a spedo sensor at the wreckers and about 20-30 bucks I think mine was a few months ago.. The auto 1 is on the left side and a little oil will come out but not much. They do have a oil seal a o ring., has 1 bolt that holds it in

[Cheap6]

Hey i was under the car a weekend or two ago and happened to take a photo of mine. It's leaking oil, i think there must be an o-ring or something that's stuffed on it. So if u can see through the muck and grot and grease and piss that's it
it's on the drivers side a far way back from the engine. Mine's a manual, dunn if that makes a difference

Between the plate and the trans. extension housing is an 'O' ring (purple, if that makes a difference ). That gets real brittle with age and heat and no longer seals.

It's an easy fix, just wash the oil and dirt off (to make the job pleasant and avoid getting crap in the trans.) and undo the sensor and the 10mm head bolt that holds the retaining plate. DIg the old 'O' ring out with a pick or scribe, clean the parts and fit the new 'O' ring. A bit of trans. oil on the ring helps it slide in.

If that 'O' ring isn't leaking, there is a seal in the end of the sensor housing - VS19145, the only Holden part # I know .

[VQ-Assault]

the o ring is $20 from holden, the speed transducer is around $400 new from holden

[defecat0r]

oh hey thanks boys, good info, i'll check it out