89 vn wagon looks and mods

[commodorekid_11]

Hey guys this is my vn wagon
I just want to get a few ideas on how to make it look good and a few ideas i can do to make it faster or more powerful
Engine is being rebuilt atm, like new rings and bearings and whole new gasket kit
Also im on my ps so no v8s lol

[mr calais 5.0]

Could turbo it.. Is the motor going stock or camed?

[commodorekid_11]

Stock atm might do a cam soon but, mild cam?

[commodorekid_11]

Thanks for the tips

[Reaper]

Hey guys this is my vn wagon
I just want to get a few ideas on how to make it look good and a few ideas i can do to make it faster or more powerful

Sell it and buy something better looking and faster. Easiest and cheapest solution all round.

Reaper

[commodorekid_11]

It wud be good if i was made of money but not everybody is so this is wat i got

[ucwepn]

clean it inside and out, lower it a bit and change the wheels, maybe venetians too make it a good cruiser. don't put money into performance its a waste wagons are heavier than statesmans, do it all as cheap as you can and start saving for a newer ride.

[ice_cold17]

ahhh the executive...we meet again...lol i cant stand those bumpers,thats why im painting mine,you could go the calais look with a two tone,thats what im doing,get a VN SS group A grille,they are the widest opening so allows the most air,cut and polish and get a buffer to remove any fine scratches,paint will come up really nice,VE SSV wheels look amazing on a VN/VP although they are expensive as hell,so some nice 5 spoke wheels would look choice,maybe 17sor 18s,that way you wont scrub the tyres and will fit nicely,go over all your black trim with black spray paint of touch up stuff,you can paint your calipers to suit,most people do red but it depends on the look of your car,lol in the words of mighty car mods "there is an extra 25kw" (however if this is a series 1 then you wont have 4 wheel disk brakes so no point in the calipers then),and find a nice exhaust tip,dont get a cannon coz they look try hard and gay. performance wise,complete exhaust sytem from the extractors through,2.5 inch usually goes well,make sure you get a high flow cat,i use a 100 cell which is the highest flow.CAI with a k&n panel filter,clean your throttle body,port the head,memcal tune,stick it on the dyno and get the whole thing computer tuned.