Speedo needle sitting on bottom of dash

[mazcom04]

Hi can some one help me. I just replaced the little cog thing in the speedo assembly (odometer) and now the speedo needle is sitting at the bottom of the dash. So when I'am doing forty its reading 0 etc can some help?
Cheers Lee

[rambunctious]

Pull the dash out again and refit the needle to the pin.

[mazcom04]

Its sitting on the pin but lines up the the bottom of the dash, so its sitting well below the 0 mark on the speedo.

[HSV5L]

I have a l3 that should fit what would you pay the lcds wont work tho.

[hsv304v8]

I would go with CHARGEDVTS the clusters arnt worth fixing

[chevyshubox]

Its sitting on the pin but lines up the the bottom of the dash, so its sitting well below the 0 mark on the speedo.

Just like rambunctious said take the dash out again and take the needle back off then rest it back on at about 40k`s then just push it down to zero and push it back on not to hard as you might not get it right first go. A fork is a good way to lever it off gently.

[mazcom04]

First of I never removed the needle it was working fine. I just replaced the cog in the odometer and when i replaced the dash It was sitting below the 0. I have tried to fix it but it just falls below the 0 zero, does it need a little stopper or something or do i just buy a whole new dash cluster cheers.

[HSV5L]

Buy mine

[mazcom04]

Thanks everybody, I fixed it with a fork and repositioned it at 0 zero and it works
Cheers Lee