pedders ultra lows.. not that low?

[vn1989]

i just put my front ultra lows in my vn. put the back ones in a while ago. but when i put them in i was supprized it wasnt as low as i thought it would be. at the front end under the sill its about 14 cm to the ground and the back is about 16 cm. but looking at it for ultra lows they dont look that low.
part numbers are 2129 for the rear
and 2124 for the front if that helps

[mr calais 5.0]

did you have the shoks and struts as well? How much lower is it from standard..

[bj42turbo]

I have a complete Pedders package in mine...If you measure from the bottom of the guards to the centre of the wheel I will measure mine for comparison..
This is the best way to measure as it eliminates any variances such as different wheel and tyre sizes and even less air in tyres

Dazz

[glenn l]

pedders dont classify the coils as low, super low ect, but the 2124's are aprox super lows not ultras, there is a 2122 thats aprox 20mm lower than a 2124 but the ride will be crap due to it riding on the bump stops. the 2129 would be similar to a ultra low for the rear, and i dont think pedders have any thing lower.

[vn1989]

I have a complete Pedders package in mine...If you measure from the bottom of the guards to the centre of the wheel I will measure mine for comparison..
This is the best way to measure as it eliminates any variances such as different wheel and tyre sizes and even less air in tyres

Dazz

its 35cm for the front and 30cm for the rear

[vn1989]

and no way would i get the 2122 springs mine sits front low already and i wanted it to sit flat :/

[bj42turbo]

its 35cm for the front and 30cm for the rear

320mm rear 335mm front

[vn1989]

does your car sit under 100 mm at the front because the lowest point of mine is just over 100 mm and yours is lower in the front than mine?

[bj42turbo]

does your car sit under 100 mm at the front because the lowest point of mine is just over 100 mm and yours is lower in the front than mine?

I will check it for you....it better be though as When I took it in I said I want it as low as possible but keep it legal and safe

sent from Dynamic Locksmiths Mobile using Tapatalk

[bj42turbo]

Put up a side on pic of yours

sent from Dynamic Locksmiths Mobile using Tapatalk

[vn1989]

there are 2 pics now very good quality and pritty small i had 2 compress them to upload them

[mr calais 5.0]

that does look pretty low mate..

[vn1989]

i guess but for ultra lows i thought the back would be lower... im fairly happy with the front

[vn1989]

what does that peice of plastic do that hangs down under the front of the motor?? do i need it cause it sits under leagl hight its the only thing under 100 mm could i just trim it abit or take it off?

[bj42turbo]

that does look pretty low mate..

Agreed that DOES look pretty low

Dazz

[vn1989]

dazz,
did u get around to measuring the lowest point of yours?