wheel bearing access???

[VN-88]

hey guys, i wana check my rear wheel bearings, i got most of the way to them, undo my hand brake and the 4 inner nuts but i cant do anything else, it wont slide out... anyone got a pics showing all parts so i no wat they are, and steps on pulling it out... thanks

[vsII manual]

You will probably have to hit it out with a soft head mallet. This is how i got mine out on my VS. Its pretty much te same set up, mines live axle not irs too.

[VN-88]

ok , but i aint sure ive undun everything, so i dont want to brake it... so i just need a parts photo, or the steps

[rattattack1313]

OK..put the drum /disc back on, and only do up the wheelnuts 2 or 3 turns.....use it as a sliding hammer....the axle willl slide out..

[VN-88]

ok rat so from the start i do this...
1. take tyre off
2. takr brake drum/caliper off
3. undo hand brake pads and undo the 4 nuts
4. put disk back on, slightly do wheel nuts up
5. pull back and forth till she ocmes off... is that right????

[VN-88]

well i manged to get the right hand bearing out, althought its not really noticeably damged, is there only the one bearing, on the wheel end of the shaft, cause mine only has the one, i hope one didnt get stuck in there,

i did notice a few little fragments of metal on the shaft, but noting serious, i cant figure out were this wind is coming from