My VN keeps on stalling! Help!

[VNDAVN]

I got vn v6. I got a chip off ebay and i installed it myself because it came with clear instructions. I had to place it in the Intake-air-temperture (IAT). It worked fine after i installed it for about a hour but later i started the car...it wants to stalled. If i get to a traffic light it wants to stall. So i removed the chip but its still the same. anyone know wat could be wrong. cheers!

[greenfoam]

was that one of those dodgy resistor things?

[Danzilla]

im guessing pretty badly here but it sounds like the "chip" you put in was just a resistor that fools your car into thinking there is less or more air coming into the engine so it adds more fuel, take the chip thingo out and disconect your battery for like 10min and then try to run your car again see if resetting your ECU fixes your problem

[andyli]

i GOT THE SAME PORBLEM AFTER i CHANGED THE AIR FILTER BOX

[Frd_thmsn]

You got all the answers you needed in your duplicate post you did,the one titled
"Map Senser".
Map Senser

I don,t see the need to duplicate your post .

It couldn,t be a blatant attempt to get free press on these 20c resistors could it?

Yes I,m a cynic

If it doesn,t work give the guy negative feedback on ebay.

But he,s too clever , he makes you give feedback before sending you the bonus information, that way he always gets positive feedback.

How do I know ? I bought one ages ago

[andyli]

clean the injector

[HDT_aero]

take the resistor out it wont make your car go harder.....

[Emackulation]

I took the bellmouth out and it went harder, but the car was running good at start up and stuff, but when i installed CAI the engine likes to surge when slowing down like coming up to lights, ive reset the ECU by holding 3k RPM for 8 secs, no diference. Maybe when i get my chip from foamie it will help...