Can people check for me, the location of where the wires for oxygen sensor are supposed to go???
According to the manual & looking at my mates VP, mine are definetly in the wrong spot. Had a code logged since having the trans done & it appears the wires now go to somewhere on the trans instead of the back of the motor or near the manifold??
Being that Im getting a 13 Id say this would be the cause? yes? no?
Help please??
D.
i will check when its not dark or cold![]()
unless someone beats me to it
Adam
sorry for taking my time.
here is a pic. and then that bunch of wires go through the firewall and im guessing to the thing behind the passenger kick panel
![]()
Adam
ah mine goes into the manifold.
i hope this is what you mean
Adam
oh and i think the series 2 engine had 2 wires.
im not 100% sure on that
Adam
The series 2's and VP's with the cast manifolds are probably like the later V8's after the VN's and would screw into the exhaust pipe down near the ground instead of into the header as per VN's, what's so hard about following the wire to the ground?.
what do you mean to the ground?
Adam
The ground/dirt/earth/under the car kinda ground
well yes mines a series 2 so 2 wires....
Prob was I was getting a 13 code & was thinking that the wires position looked dodgy.... well after having it up on the hoist today.... voila!! I see that it is disconnected as I thought & found the other plug & now is all good!!
Thx for the pics adam! Was definetly too hard for me to see from the top & I really did need to see it from under to really know what the deal was (yes Im blonde)
D.