heater tap

[12000]

i was wondering my heater still blows cold air when you turn the fan over to the heater on all settings demister, fresh and recirculate when i move the bit thet goes in a cylinder on the heater tap it then moves out again is that bit suposed to stay in or am i up for a new heater tap. also what settings do i have to have for the heater to work


http://cgi.ebay.com.au/Heater-tap-VN...QQcmdZViewItem

[xcop5l]

just have it on hot with the fan in

id sugest you check the rod that controlls the heater flap is conected and adjusted properly

[pow3rslave]

yeah what he said^
the heater dial connects to a metal rod that runs down to a white plastic arm that's kinda located where the centre console meets the fuse panel.

just check that for a start, also check that the pipe behind the heater tap (the vacuum hose) is connected to it.

that's where i'm up to now. i chucked a new heater tap in mine, checked that rod, but still no luck. i think there's something between the two points that's not functioning in mine. just haven't pulled the centre console off to check it out.