Car stalled now wont start HELP!!

[TwilightFlame]

well im clueless.. i replaced the harmonic balancer took the car out for a spin ran fine no jerking or nuthing went fine for about 20 km then when i was going around a corner engine just stalled now it wont start at all. it kicks over it just dont start. any ideas ???

[Vt-Brrrlina]

crank angle sensor - make sure the wiring is in place or u havent knocked it out of place - it sits behind the harmonic ballancer nd causes all sorts of dramas id look there first

[TwilightFlame]

yea i dident knock it all rdy cheaked it looks fine but next door nabour says i most proply will need a new sensor. any other ideas?

[Vt-Brrrlina]

did u get the right harmonic ballancer for the car - my mate had a vp engine in his vn and got the wrong one - was a problem and car diidnt start - needed engine number to get the right ballancer - fired straight up then - on another note - if the crank angle sensor is buggerd its terminal - car wont start .... and they are easy to break

[Zuicider]

did u get the right harmonic ballancer for the car - my mate had a vp engine in his vn and got the wrong one - was a problem and car diidnt start - needed engine number to get the right ballancer - fired straight up then - on another note - if the crank angle sensor is buggerd its terminal - car wont start .... and they are easy to break

I have a vr harmonic balancer running on my vn series one, works a treat.

have u tightened and pushed the harmonic balancer all the way back?

[TwilightFlame]

its the right one car was going perfectly till it stalled now it wont do nuthing im gonna take it to the garage 2 moz and get the sensor looked at