Cruise Control On Manual VR SS sedan

[mectec]

I have installed all components need for the crusie control on my manual including stalk, crusie module cable and bracket, both brake and clutch switchs in series. Now when i hit the on button the bcm is clicking but nothing is coming up on the dash. I used a test light on the module plug and when i hit on (the stalk) i find i get a extra pin with power at the module but nothing will work. I have upgraded the BCM to a vr clubsport one with is a mid number one. Is there a relay or somthing need for the crusie control to work or do i need to do some re-wiring. All the plugs were there for all this to be plugged in. No wires i have added.

Cheers

[hako]

You need a relay which goes under the steering wheel where the other relays are - check the fuse/relay location instructions on the drop down panel and look for the location of the cruise control relay - I think it's to the left of the flasher relay. It's just a normal small relay identical to others already fitted.
Good Luck.

[keza87]

I don't know about the relay somewhere under the steering wheel as I didn't need one when I installed mine.
Did you connect up the dash lights? The 'on' light should come on when you have power going to the cruise module. The power should come from the BCM if connected correctly and the on/off switch should connect to the BCM while the acc/deceleration buttons go directly to the cruise module.
There should also be a wire from the cruise module to the dash to indicate cruise is active.
For the pedal switches, you will also need to connect into the brake light switch as a secondary backup. This will be a separate wire to the clutch and brake switches.