IRS Camber SSSL

[gelousi]

Hey the other day i noticed my rear right has neg camber and rear left is straight as! the car is sitting on SSSL Kings so ide assume they both should have neg camber? it dosnt have a camber kit or anything like that, makes no noises or clunks. Can the left wheel be aligned or is something bent? i had a quick look under but dont really kno what to look for as this is my first irs setup

thanks

[Disturbed_vegeta]

irs should always have camber....unless something is bent.

[gelousi]

Yeh it should have camber on both sides, its only got negative on the right, the left is dead straight. Even when jacked up the left doesn't look the same as the right

[sweefu]

Maybe something could be bent..

[gelousi]

hmm see thats what i was thinking but ive had sevral looks and cant find much, bought a workshop manual and it says to undo 4 nuts while on the ground bounce the car afew times and it should balance the wheels but its hard when the car is so low lol ill try putting it up on ramps and see how i go.

[BT1-355]

hmm see thats what i was thinking but ive had sevral looks and cant find much, bought a workshop manual and it says to undo 4 nuts while on the ground bounce the car afew times and it should balance the wheels but its hard when the car is so low lol ill try putting it up on ramps and see how i go.

I recommend taking it to a wheel aligment place eg bob jane, tyre power etc etc and get them to measure your rear camber just to be 100% sure you got a postive camber. Sometimes your eyes can play tricks on you

[_R_J_K_]

Is it anything like this thread? - Strange camber issue

[gelousi]

Nah not that bad, like the right sits how it would with sssl's but the left is like 0camber probably even positive and looks really gay! ive checked for a cracked cradle but it all looks good. Yeh i might just take it to a bob jane or something like that and see how i go. Ill see if i can get a pick up tonight and show u

thankss

[Room42]

get an adjustable panhard rod and get it aligned properly

[Verynice]

get an adjustable panhard rod and get it aligned properly

maybe if it was a solid axle....

[Not_An_Abba_Fan]

Take it to someone who knows how to do a 4 wheel alignment, I'd say it just needs adjusting if it has a kit. If it doesn't have a kit then it can't be adjusted and something is probably bent or a bush is flogged out.

[gelousi]

well ended up going to pick a part and bought the Y looking peice with a axle and hub for $85 and layed my one next to the new one and it was bent! looks like it was gutterd or something but put it on and now it looks normal haha

LOL at room42 sorry mate irs dont run panhard rods....