Vr commodore auto to manual

[kylej]

Hi guys i was just wondering whats needed to put a 5 speed manual to put into my vr s2 and what changes do i need to do to the wireing harness or what do i have to raplace on the harness to make it all run sweet and also what do i need to change on the computer/ecu

thanks all regards kyle

[v6lux]

The ECU is totally different, no auto commands or cam angle sensor needed. So you are better off getting a VN - VR manual engine loom for the engine and equivalent ECU.

You will not be able to run the current VR auto ECU!

[delcowizzid]

you can run the auto ecu with all the error codes turned off and get away with it .sometimes get the odd stalling issue when pulling up to a stop which you can stop by turning the idle screw up a bit.but its best to fit a manual ecu which for vr is near impossible to find so you use a vn ecu and loom instead then the ecu will have a speed sensor input and makes it much happier

[v6lux]

OK, you can believe this guy ^.

PS, I got a factory VR V6 man ECU in my Hilux!

[dk4400]

Is it a T-bar auto or a column auto at the moment?

[kylej]

she is a t bar auto.
delcowizzard i found a vs series 2 commodore but the previous old bat owner cooked the motor i was wondering if i can rip the 5 speed and running gear out and bolt it upto mine with its wireloom and computer. would i have any issues at all what do u think

[bandit10]

you cant use a VS engine loom and computer on a VR, different engines.. you need a VN-VR engine loom and computer.. of which i have