Vr level 3 dash speedo not working after upgrade. one wire to go help...

[dk4400]

I have connected the wires to the corresponding colored wires on the speed sensor, but im left with a black with white stripe wire left out of the three and im not sure where this goes, there are 2 solid black wires there but not sure if I should tap into one of these.
PLEASE HELP, im almost there

[88GreenVN]

The 2 black white wires from the 4th plug - join together. Then the single black white goes to C2#6 I think.

A black white wire will need to splice into a black white wire some place.

[dk4400]

Its all good, thanks 88GreenVN, I managed to work it out, I should have read down the page a bit as there is a thread on here
showing where the wires go in relation to the speed sensor
Thanks for your help tho it would not have been something I would normally tackle as I hate electrics.
Now I just have to solder up the wires and its all done, and it all WORKS
Now I just have to work out why my vacume control on the dash doesn't work
Always something to do......