what's the go with these pipe's?

[darcycammo]

Every time i have tried to take one of these out of a VS and up it all ways snaps off at the end that sticks into the water pump (you can't see it in this photo tho)

[FstStig]

That goes into you're water pump!

[klampy]

iv never snapped one?? :/

[Sabbath']

Never had a problem. Done quite a few aswell. Must be your technique. Dont be so rough.

[vscaprice98]

if u snap one again i suggest that job is not for u
lol

[darcycammo]

if u snap one again i suggest that job is not for u
lol

Hahaha Yer we will find out 2morrow i will go down to the wreckers and pull a couple of them off and see what luck i have

[mischa]

I snaped one, wasent my engine. I said it felt to tight but he just said keep going

[darcycammo]

I snaped one, wasent my engine. I said it felt to tight but he just said keep going

yer well both times i did it i did the same thing as you body i told myself to do it LOL

[VR_Acclaim]

Ive never broken one amazingly i have how every shared the input shaft to the water pump clean in half some how

[darcycammo]

off to the wrecker's soon i keep you updated on how many i brake haha

[VR_Acclaim]

just be gentle with them

[Cracka]

heheh, ive broken one too, the trick is to gently lever it evenly out.

Was a mongrel to get the broken bit out of the hole too.

[darcycammo]

Okay so i went to the wreckers and both of times i tried taking them out of to different cars they both came out easy where is i couldn't get it out of my car 2 time's with out braking it

[Paul13pp]

Keep the coolant with lubricant fresh in your engine and parts like this wont corrode and sieze

[darcycammo]

Keep the coolant with lubricant fresh in your engine and parts like this wont corrode and sieze

Ever since i have had this car (April 2010) it has had coolant in it but the person i brought it from didn't look after the car to well that's why i'm pulling most of the thing's apart to fix or clean like right now im doing the manifold gasket and im going to clean all the top of the motor and part's maybe spray paint it all silver again to make it look a bit more new

[GTP 85]

If they are tight its just a matter of carefully leavering on each side. It will snap when the 'male' part sits slightly off line and catches on the tube.

Ive snapped one before due to being a bit impatient lol